Eurosystems TR 80 Manuel D'utilisation Et D'entretien page 38

engine running may damage the me-
chanical parts of the PTO power take-
off, compromising the operation of the
power transmission between the ma-
chine and the accessory.
ATTENTION!
After coupling the accessory, put the
wheel into pos. "R-A" for transfer, or
into pos. "R-C" for cutting.
5.3. TOOL/ACCESSORY
UNCOUPLING [ fig. 07, 08, 09 and 10]
• Switch the engine off. The wheels
should be placed on the ground Posi-
tion "R-B" [ fig. 05]
the handle [ 3, fig.
• Make sure that the PTO lever [22] is
in the neutral
• Release the parking brake by mov-
ing the lever [25] into the position of
;
• Open the fixing hooks moving the le-
ver [26] into the position
• Exert pressure on the handlebars
from below upwards in such a way that
the front of the machine slides off the
tool.
EN-10
, if necessary, turn
11].
position;
;
5.4. CUTTING HEIGHT ADJUSTMENT
[ fig. 06]
ATTENTION!
Never carry out adjustments with the
engine switched on. Always remove the
ignition key and/or the spark plug cap
before working on the accessory to pre-
vent sudden or unexpected starting.
ATTENTION!
After switching the accessory off, leave
the hot surfaces to cool down for at le-
ast 15-20 minutes before approaching.
ATTENTION!
Always wear gloves and safety shoes
and use proper equipment when adju-
sting the cutting height.
The cutting height can be adjustable in 2
different ways : 1) with the wheels; 2) with
the slides.
1) For the use with the wheels :
please look at chapt. 5.1 by acting on
the handle [ 3, fig.
2) For the use with slides
The flail mower is supplied with the
screwed slides for 2 cm cutting height
(height position S-A ) . To adjust the
height to 4.5cm (position. S-B) or to
11].
[ fig. 06]