Publicité
Les langues disponibles
Les langues disponibles
Pos. C)
Full height : for the grass cut in order or
avoid blockage.
5.2. ATTACHMENT THE TOOL/
ACCESSORY
[ fig. 07, 08, 09 and 10]
The accessory should be put on the
ground, in horizontal position and both
wheels to lean on the ground in Posit "R-
B".
• Make sure the machine's engine is
off;
• Make sure that the PTO lever [22] is
in the neutral
• The wheels should be placed on the
ground in Position "R-B"
necessary, turn the handle
• Release the actuating brake by mo-
ving the lever [25] into the position of
;
• Move the lever [26] in the
sition as shown in
• Check the front hooks [8] present
on the machine are open as shown
in
[ fig. 08
];
• Pushing the machine, bring it near
to the front part of the tool with an in-
clination of approximately 30° to the
ground as shown in
• Once the pin [2] of the accessory
is resting on the guides [3]
push the machine, bringing the front
position;
[ fig. 05]
, if
[ 3, fig. 11]
po-
[ fig. 08
];
[ fig. 07 ]
;
[ fig. 09 ]
part to the horizontal position as
shown in
[ fig. 09 ]
• Make sure that the pin [2] is at the
end of the guides [3]
• Operate the tool coupling lever [26]
bringing it into the position
shown in
[ fig. 10 ]
ATTENTION!
Before starting the machine, check if
the machine-accessory connection has
been carried out correctly by following
the procedure below:
• When the engine is completely
switched off, press the bypass lever
[24] and operate the clutch lever [22],
locking it in the operating position;
• Holding a hand on the bypass le-
ver [24] slowly pull the engine starter
rope;
• The machine-accessory connection
will be active when, by slowly pulling
the cord, it will be possible to haul the
moving parts of the accessory.
INFORMATION:
During the a.m. operations a "CLACK"
sound can be heard when the pin on the
accessory falls inside the joint on the
machine.
ATTENTION!
Performing this procedure with the
;
[ fig. 10 ]
;
as
;
EN-9
Publicité
