Safety Instructions - Festool MFK 700 EQ Notice D'utilisation D'origine

MFK 700 EQ
GB
Original operating manual
1 Symbols................................................ 12
2

Safety instructions ............................... 12

3 Intended use ........................................ 13
4 Technical data ...................................... 13
5 Items included ..................................... 13
6 Operation.............................................. 13
7 Settings ................................................ 14
8 Working with the machine ................... 15
9 Service and maintenance .................... 15
10 Accessories .......................................... 16
11 Environment......................................... 16
12 EU Declaration of Conformity.............. 16
The specified illustrations appear at the beginning
of the Operating Instructions.
1 Symbols
Warning of general danger
Risk of electric shock
Read the Operating Instructions/Notes!
Wear ear protection.
Wear a dust mask.
Wear protective goggles.
Wear protective gloves.
Disconnect from the power supply!
Do not throw in the household waste.
2 Safety instructions
2.1 General safety instructions
WARNING!
Read all safety warnings, in-
structions, illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future ref-
erence.
12
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
2.2 Machine-related safety instructions
- Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal
parts of the power tool "live" and could give the
operator an electric shock.
- Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by your hand or against the
body leaves it unstable and may lead to loss of
control.
- Check that the cutter is firmly fitted and runs
freely.
- The clamping collet and union nut must show no
signs of damage.
- The tools must be rated for at least the speed
marked on the power tool. Tools running over
rated speed can fly apart and cause injury.
- Only tools which satisfy EN 847-1 can be used. All
Festool cutters meet these requirements.
- Only cutters provided by Festool for this pur-
pose may be mounted on the power tool. The
use of other cutters is prohibited due to the in-
creased risk of injury.
- Never use dull or damaged mortising bits. Dull
or damaged mortising bits can cause the tool to
lurch sideways unexpectedly and lead to a loss of
control of the power tool.
- The clamping collet should only be used to clamp
tools with a shank diameter appropriate for the
collet.
- Only guide the machine against the workpiece
when it is switched on.
- Do not cut metal objects, nails or screws.
- Wait until the power tool stops completely until
placing it down. The tool can become entangled
and lead to a loss of control of the power tool.
- Do not allow hands to reach into the cutting area
and come into contact with the cutter. Use your
second hand to hold the additional hand grip or
the motor housing.
- Wear suitable protection: such as ear protec-
tion, safety goggles, a dust mask for work which
generates dust, and protective gloves when
working with raw materials and when changing
tools.