Metal Processing; Emission Levels; Intended Use; Technical Data - Festool MFK 700 EQ Notice D'utilisation D'origine

– Harmful/toxic dust may be produced during
your work (e.g. paint containing lead, certain
types of wood and metal). Inhaling or coming
into contact with this dust may represent a haz-
ard for operating personnel or persons in the vi-
cinity. Comply with the safety regulations that
apply in your country.
Wear a P2 dust mask to protect your
health.
2.3

Metal processing

When processing metal, the following mea-
sures must be taken for safety reasons:
– Install an upstream residual-current circuit
breaker (FIG, PRCD).
– Connect the machine to a suitable dust extractor.
– Regularly remove dust deposits from the motor
housing of the machine by blowing.
Wear protective goggles.
2.4

Emission levels

Levels determined in accordance with EN 60745 are
typically:
Sound pressure level
Noise level
Measuring uncertainty allow-
ance
CAUTION
Operating noise
Damage to hearing
Use ear protection!

Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
Vibration emission level
(3 directions)
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during

operation.

– They represent the primary applications of the
power tool.
L = 78 dB(A)
PA
L = 89 dB(A)
WA
K = 3 dB
(vector sum for three
h
a = 3,0 m/s
h
K = 2,0 m/s
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
3

Intended use

The power tool is designed for routing wood, plastic
and similar materials.
The user is liable for improper or non-in-
tended use.
4

Technical data

Modular router
Power
Rotational speed (no load)
n
0
Tool holder
Max. routing tool diameter
Dust extractor connection diameter
Weight (excluding cable)
Safety class
5

Items included

[1-1] MFK 700 with large surface router table
Side stop with guide rods and fine adjuster
[1-2]
Extraction hood for large surface router
[1-3]
table with extractor connector
Router table for edge veneer with feeler
[1-4]
roller and extraction hood (only in SET
scope of delivery)
Handle, locking for routing depth
[1-5]
6 Operation
Unauthorised voltage or frequency!
Risk of accident
2
The mains voltage and the frequency of the pow-

er source must correspond with the specifica-
2
tions on the machine's name plate.
In North America, only Festool machines with

the voltage specifications 120 V/60 Hz may be
used.
Always switch the machine off before con-
necting or disconnecting the mains power
cable!
Connecting and detaching the mains power cable -
see Fig. [3].
MFK 700 EQ
MFK 700 EQ
10000-26000 min
(optional : 6 mm, 1/4'')
WARNING
GB
720 W
-1
8 mm
26 mm/ 1''
27 mm
1,9 kg
/II
13