Settings; Changing Tools - Festool MFK 700 EQ Notice D'utilisation D'origine

MFK 700 EQ
GB
The switch [2-2] is an on/off switch (I = ON, 0 =
OFF).
7

Settings

WARNING
Risk of injury, electric shock
Always pull the mains plug out of the socket be-

fore performing any type of work on the ma-
chine!
7.1 Electronics
The machine features full-wave phase control elec-
tronics with the following features:
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Speed adjustment
You can regulate the speed steplessly between
10000 and 26000 rpm using the adjusting wheel [2-
1]. This enables you to optimise the cutting speed to
suit the material.
Constant speed
The motor speed remains constant through elec-
tronic control to ensure a uniform cutting speed
even when under load.
Temperature control
To prevent overheating, the safety electronics
switches the machine off when it reaches a critical
motor temperature. Let the machine cool down for
approx. 3–5 minutes before using it again. The ma-
chine requires less time to cool down if it is running,
i.e. in neutral position.
7.2 Replacing router table
The large surface router table is already fitted as
standard. The large contact surface and precision
adjustment features of this router table enable a
high degree of accuracy. Other router tables are in-
cluded in the accessories programme.
a) Large surface router table
Slide the router table onto the retaining pin on

the machine.
Tighten the screw [4-1] to clamp the router ta-

ble in position.
Place the extraction hood [4-2] in position.

Tighten the screw [4-3] to clamp the extraction

hood in position.
Place the extractor connector [4-4] on the ex-

traction hood.
14
Removal in reverse order.
b) Router table for edge veneer
The "router table for edge veneer" (only in SET
scope of delivery) is designed for flush trimming
veneer overhang and profile routing.
 The router table is tilted 1.5° so that the surface
coating is not damaged during edge routing. A
router table with 0° inclination angle for precise
cuts is available as an accessory.
Secure the sensor [5-1] to the machine using

the preassembled screws. Slide the sensor in
the long holes to adjust the routing tool to the
perfect position.
Slide the router table onto the retaining pin on

the machine.
Tighten the screw [5-2] to clamp the router ta-

ble in position.
Place the extraction hood [5-3] in position.

Tighten the screw [5-4] to clamp the extraction

hood in position.
Removal in reverse order.
7.3

Changing tools

CAUTION
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-

tive.
Wear protective gloves.

Before replacing the cutter remove the router table
- see chapter 7.2.
Removing the tool
Push spindle lock [6-1].

Slacken union nut [6-2] using open ended span-

ner (SW 19) until the tool can be removed.
Release spindle lock [6-1].

Inserting the tool
Position the cutter [6-3] as far as possible, at

least as far as the marking
shaft, into the open clamping collet.
Push spindle lock [6-1].

Tighten union nut [6-2] using open ended span-

ner (SW 19).
Release spindle lock [6-1].

7.4 Replacing clamping collet
Only suitable tools can be used with the supplied
collets. Collets with 8 mm, 6 mm and 1/4"
(6.35 mm) can be used.
at the cutter