Dometic PERFECTVIEW CAM360 Instructions De Montage page 37

CAM360
If you see an offset in the side measuring tapes (fig. n, page 11):
➤ Change the "WIDTH" parameter.
➤ Check the image.
➤ Repeat these steps until no offset is visible.
If you detect an offset in the rear measuring tape (fig. o, page 12):
➤ Change the "LENGTH" parameter.
➤ Check the image.
➤ Repeat these steps until no offset is visible.
After fine adjustment:
➤ Select "SAVE INTERNALLY" to save the configuration including calibration to the
internal storage.
➤ Select "SAVE EXTERNALLY" to also save the configuration including calibration
to an external storage device (SD card or USB).
If you use the distance lines of the rear camera:
➤ Align the distance lines by adapting the parameter "AUX LINE START" (refer to
chapter "Setting a SINGLE CAMERA" on page 32).
EN
Video system settings
37