Dometic PERFECTVIEW CAM360 Instructions De Montage page 15

CAM360
A
NOTICE!
• To prevent the risk of short circuits, always disconnect the negative
terminal of the vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should
also be disconnected.
Please note the following:
• When working on the following cables, only use insulated cable terminals, plugs
and flat sockets:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– Reversing light
– Right/right indicators
Do not use porcelain wire connectors.
• Use a crimping tool (fig. 1 9, page 3) to connect the cables.
• Screw the cable when connecting cable 31 (earth)
– using a cable terminal and serrated washer to one of the vehicle's earth bolts
or
– screw the cable to the bodywork using a cable terminal and a self-tapping
screw
Make sure there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
• The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
Observe the following mounting instructions:
!
CAUTION!
• Secure the parts of the video system installed in the vehicle to ensure
they cannot become loose under any circumstances (sudden braking,
accidents) and cause injuries to vehicle occupants.
EN
Safety and installation instructions
15