Dometic PERFECTVIEW CAM360 Instructions De Montage page 24

Installing the video system
To perform the installation, proceed as follows:
Use the supplied self-tapping screws
A
NOTICE!
Self-tapping screws may only be fastened to steel metal with a minimum
thickness of 1.5 mm.
➤ Drill a hole of Ø 6 mm for the cable entry (fig. d, page 8).
➤ Guide the camera cable into the vehicle interior (fig. e, page 8).
➤ Mark the holes for the mounting screws (fig. f 1, page 8).
➤ Remove the camera (fig. f 2, page 8).
➤ Drill two holes of Ø 2.4 mm for the camera bracket (fig. g, page 8).
➤ Guide the camera cable into the vehicle interior (fig. h 1, page 8).
➤ Screw on the camera with the included self-tapping screws (fig. h 2, page 8).
If you would like to attach the camera with threaded screws fitted through
the construction:
A
NOTICE!
Ensure that nuts cannot be pulled through the body shell when they are
tightened. Use larger washers or metal plates if necessary.
➤ Drill a hole of Ø 6 mm for the cable entry (fig. d, page 8).
➤ Guide the camera cable into the vehicle interior (fig. e, page 8).
➤ Mark the holes for the mounting screws (fig. f 1, page 8).
➤ Remove the camera (fig. f 2, page 8).
➤ Drill two holes of Ø 3.5 mm for the camera bracket.
➤ Guide the camera cable into the vehicle interior.
➤ Screw on the camera with M3 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
24
CAM360
EN