Yamaha SPX50D Manuel D'utilisation page 22

23
Release Time (RELEASE): 5 — 32000 milliseconds
| 41. Overdrive Hall |
42. Distortion Room
Distortion Level (DISTORTION): 0 — 100%
Sets the "degree" or "depth" of the distortion portion of the
effect.
Reverb Balance (REV BAL): 0 — 100%
This parameter produces a delay between the arrival of the
input signal and the beginning of the reverb effect.
Reverb Time (REV TIME): 0.3 — 99 seconds
The length of time it takes for the level of reverberation at 1
kHz to decrease by 60 dB.
Trigger Level (TRG. LEVEL): 1 — 100
Determines the amplitude of the input signal required to trig-
ger the effect. This parameter, in conjunction with the RE-
LEASE parameter below, functions effectively as a noise
gate to cut out hiss and noise when an input signal is not
present. TRG LEVEL should be set so that the effect is
activated only when a note is played on the instrument
used.
Release Time (RELEASE): 5 — 32000 milliseconds
Determines the amount of time it takes for the distortion
to allow a natural decay of the source instrument sound.
43. E/R Distortion
44. Slide Gate i |
These programs combine early reflections with the distortion
effect.
Distortion Level (DISTORTION): 0 — 100%
Sets the "degree" ог "depth" of the distortion portion of the
effect.
E/R Balance (REV BAL): 0 — 100%
Tone (ТОМЕ): 500: — 4000 Hz
This parameter produces a tonal emphasis in the selected
frequency range.
Room Size (ROOM SIZE): 0.1 — 20
Liveness (LIVENESS): 0 — 10
Delay (DELAY): 0.1 — 400 milliseconds
Trigger Level (TRG. LEVEL): 1 — 100