Publicité
Les langues disponibles
Les langues disponibles
2: GENERAL OPERATION
MEMORY CONFIGURATION
The SPX50D has a total of 100 internal memory locations. Lo-
that although a new location has been selected, its con-
cations 1 through 50 are READ-ONLY MEMORY containing the
tents have
not yet been recalled.
50 preset effect programs. These locations cannot be written to
|
or changed
in any way. The effect programs contained in
Ф When the desired memory location/effect has been se-
memory locations 1 through 50 are:
lected,
press the RECALL button. The LED memory
number display will stop flashing and the selected effect
с
Program Name
Mer Program Name |
will be engaged.
ae
del.
Carta
| 27 | Siphon |
Сз | Revs Hat] 28 | ADR-Noise Gate.
BEER
ne TE
Ls | Revs Room || 20 | Reverb a баю |
[e| еге маош | ап | РА
|
u
7 Rev 7 Voce! ^ | за | Pi B —
|
a | Rea voca
| as | Pinc |
Ls | Revo Pate — | 34 | Triggered Pan |
[io [ Rev 10 Piate — | as | Paramenie eo |
Сат | Eary Ret. |36 | Me Band Drive |
ia | Ему весе
[s | Heaw Менг —
Газ | Percussion Е 96 он Di, |
7341 Gate Reve. | 20 | Churky Phy
Гав | вина Gas -| 49
Tee
rae реву
141 | Overdrive Hall |
[ з т
Delay зна — | 42 | Distortion Room |
Ce | Deisy Long — | 49 | Em Оши |
Cao | Echo Shot | 4a | side Gate" |
[ж Echo Long — | as | Delay Die —
Fei | Stereo Flange | 46 | Dist Fior |
2a | chwisA
| 47 | Flange Dst |
9 |
Газ | Chon
as сканов
|
Chorus С
| 49 | Phase Dis
|
^
| 25 | Stereo Phasing | 50 | Symphonic Dist.
A complete description of each effect program and its parame-
ters is given in "3: DESCRIPTIONS OF THE EFFECT PRO-
GRAMS & THEIR PARAMETERS" ON PAGE 13. Locations 51
through 00 are READ/WRITE MEMORY which can be used to
store your own edited versions of the preset programs.
RECALL
Selected Effect
@ Press the MEMORY button to engage the memory selection
mode. This
is not necessary if the memory selection mode
is already active, but it's a good habit to get into to ensure
smooth operation.
® Press the /\ or V button to increment or decrement the
memory
location number shown on the LED display. Hold
either of these buttons down for continuous incrementing or
decrementing. The name
of the program corresponding to
the currently selected memory
location will be shown on the
LCD, or " жжж NO DATA же" will be displayed if a mem-
ory location between 51 and 00 is selected into which an
edited effect program has not been stored. Note that at this
stage the LED memory number display is flashing, indicating
Publicité
