Publicité
Les langues disponibles
Les langues disponibles
HYDRA X
6.4
CLEANING THE OUTSIDE OF THE UNIT
Danger of short circult through penetrating
water!
Never spray down the unit with high-pressure
Attention
water or high-pressure steam cleaners.
Do not put the high-pressure hose into solvents.
Use only a wet cloth to wipe down the outside of
the hose.
Wipe down unit externally with a cloth which has been
immersed in a suitable cleaning agent.
Ensure the telescoping tubes (fig. 12, item 1, x2) of the motor/
pump lift system and the actuator rod (2) are clean before
returning the motor/pump to the storage position.
1
1
1
2
6.5
CLEANING THE FILTER SCREEN
A clean filter screen always guarantees maximum
i
feed quantity, constant spraying pressure and
problem-free functioning of the unit.
1. Screw off the filter (Fig. 14) from suction tube.
2. Clean or replace the filter.
Carry out cleaning with a hard brush and an appropriate
cleaning agent.
6.5
CLEANING AIRLESS SPRAY GUN
Clean the spray gun after each use.
i
Refer to the spray gun manual for complete
cleaning instructions.
1. Rinse airless spray gun with an appropriate cleaning agent.
2. Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
3. Thoroughly clean the outside of the airless spray gun.
CLEANUP / MAINTENANCE
21
Publicité
