Titan 2412275K Mode D'emploi page 20

CLEANUP
6
CLEANUP
The sprayer, hose, and gun should be cleaned
thoroughly after daily use.
permits material to build up, seriously affecting
Attention
the performance of the unit.
Always spray at minimum pressure with the gun
nozzle tip removed when using mineral spirits
or any other solvent to clean the sprayer, hose,
or gun. Static electricity buildup may result in a
fire or explosion in the presence of flammable
vapors.
6.1
SPECIAL CLEANUP INSTRUCTIONS FOR USE
WITH FLAMMABLE SOLVENTS
•
Always flush spray gun preferably outside and at least one
hose length from spray pump.
•
If collecting flushed solvents in a one gallon metal
container, place it into an empty five gallon container, then
flush solvents.
•
Area must be free of flammable vapors.
•
Follow all cleanup instructions.
6.2
CLEANING THE SPRAYER
1. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual, section 4.7.
2. Remove the gun tip and tip guard and clean with a brush
using the appropriate solvent.
3. Place the siphon tube into a container of the appropriate
solvent.
Use only compatible solvents when cleaning
out oil based enamels, lacquers, coal tar, and
epoxies. Check with the fluid manufacturer for
Attention
the recommended solvent.
4. Place the bleed hose into a metal waste container.
5. Set the pressure to minimum by turning the pressure
control knob fully counterclockwise.
6. Open the bleed valve by rotating the bleed valve handle
fully counterclockwise.
7. Start the engine (see section 4.2).
8. Turn the master power switch ON (I).
9. Allow the solvent to circulate through the sprayer and
flush the paint out of the bleed hose into the metal waste
container.
10. Close the bleed valve by rotating the bleed valve handle
fully clockwise.
20
Failure to do so
11. Trigger the gun into the metal waste container until the
12. Continue to trigger the spray gun into the waste container
13. Follow the "Pressure Relief Procedure" found in the
14. Store the sprayer in a clean, dry area.
Attention
6.3
1. Follow the "6.2 Cleaning the Sprayer" procedure
2. Push and hold the solenoid button until the piston reaches
3. Continue to hold the solenoid button until the engine
4. Turn the engine key to the off position
5. Release the solenoid button.
Earth the gun by holding it against the edge of
the metal container while flushing. Failure to do
so may lead to a static electric discharge, which
may cause a fire.
paint is flushed out of the hose and solvent is coming out
of the gun.
until the solvent coming out of the gun is clean.
For long-term, cold weather storage, or any
i
freezing temperature exposure pump mineral
spirits through the entire system.
For short-term storage not exposed to freezing
temperatures when using latex paint, pump
water mixed with Titan Liquid Shield through
the entire system (see Accessories section of this
manual for part number and product label for
dilution instructions).
Operation section of this manual, section 4.7.
Do not store the sprayer under pressure.
PARKING PROCEDURE
Use this procedure when working with moisture
i
cured materials so no part of the fluid section is
exposed to the environment which can cause
damage to the packings
fully down position (fig. 11, item 1).
stops turning.
HYDRA X