Publicité
Les langues disponibles
Les langues disponibles
Do not use cleaning agents contain-
ing acids or chlorides to clean the
water pool on the base of the oven.
Do not clean the lime that may form
in the water pool on the oven base
by scraping. Otherwise, the product
base shall be damaged.
In order to increase the efficiency of de-
scaling likely in the water pool, in addi-
tion to the descaling steps above, after
every 10 uses:
Select an operating function in which the
lower heater is active and operate the oven
at 100 °C for 2-3 minutes. Then, turn off the
oven and spray the inside of the oven and
grill cleaner recommended on the website
for the brand of your product into the water
pool on the floor of the oven and leave for 5
minutes. After 5 minutes, wipe the pool of
water on the floor of the oven with a damp
microfiber cloth and dry it.
7.5 High temperature self-cleaning
The oven is equipped with a pyrolysis fea-
ture. The oven heats up to a temperature of
approximately 420-480 °C and burns until
the existing dirt turns to ash. A strong
smoke may be generated. Provide good
ventilation. High-temperature cleaning
should be performed after approximately
every 10 uses of the oven.
General warnings
Hot surfaces cause burns!
Do not touch the product during
self-cleaning and keep children
away from the product. Wait at
least 30 minutes before removing
the residue.
• Before using the pyrolysis function, re-
move all accessories, the telescopic
shelf and the side shelves (if any). If not
removed, the accessories and side wire
shelves will be damaged.
• If your product has a pyro proof access-
ory (resistant to high temperature self-
cleaning), you do not need to remove
these accessories from the oven.
Whether your accessories are pyro-proof
or not is specified in the accessories sec-
tion. If not specified, your accessories
are not resistant to high temperatures. It
must be removed from the oven before
cleaning to avoid damage.
• Do not clean the door seal. The glass
fiber seal is very delicate and easily dam-
aged. If the door seal is damaged, re-
place it with a new one from an author-
ized service.
• Drain the water tank before selecting the
self cleaning function with high temperat-
ure. As the interior of the oven will reach
higher temperatures during cleaning, high
noise and damage to the interior surface
of the oven may occur if water is sup-
plied to the inside of the oven.
To start the pyrolysis function:
1. Remove all accessories inside the oven.
In the models with wire shelves, remem-
ber to remove the wire shelf.
2. Before starting the cleaning, clean the
outer surfaces of the oven and the food
residues inside the oven with soapy
cloth.
3. Select the "pyrolysis" (Pyrolysis) func-
tion.
ð The "P2:00" flashes on the display.
If your appliance is equipped with
the Eco pyrolysis function, the
"Pro" message is displayed on the
display for 2 seconds first, and
then the P2:00 message starts to
flash.
If the "Pro" and then the "ECO"
messages are not shown on the
display, your appliance is not
equipped with the Eco pyrolysis
function.
4. Turn the temperature knob to the
highest "max" (maximum) temperature.
EN / 35
EN
FR
Publicité
