Ryobi RYAC160 Manuel D'utilisation page 19

 Inspect moving parts for damage, breakage, and wear.
Have repairs made on any damaged or missing parts.
Check blade for damage, uneven, or excessive wear and
replace blade if these conditions exist.
 Lower the handle assembly as described earlier in this
manual.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Mower not starting.
Mower cutting grass unevenly.
Mower not mulching properly.
Mower hard to push.
Mower not bagging properly.
Mower vibrating at higher speed.
Motor stops while cutting.
MAINTENANCE
 Store mower indoors in a clean, dry place out of the reach
 Do not store near corrosive materials such as fertilizer or
TROUBLESHOOTING
POSSIBLE CAUSE
Handle locks not locked.
Power supply not connected.
Lawn is rough or cutting height not set
properly.
Wet grass clippings sticking to the
underside of the deck.
High grass, rear of mower housing
and blade dragging in heavy grass, or
cutting height too low.
Cutting height set too low.
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Cutting height set too low.
15 — English
of children.
rock salt.
Lock upper and lower handle locks.
Connect to power supply.
Adjust the cutting height.
Wait until the grass dries before mowing.
Raise cutting height.
Raise cutting height.
Replace the blade.
Stop the motor and disconnect power
supply. Inspect for damage. Have
repaired by an authorized service
center before restarting.
Raise the cutting height.
SOLUTION