Publicité
Les langues disponibles
Les langues disponibles
Panel lock
You can use the child safety panel lock to prevent
children from accidentally turning the cooktop on.
Turning the panel lock on
The cooktop must be turned off.
Touch Panel Lock for 4 seconds. The
Panel Lock lights up for 10 seconds. The cooktop is now
locked.
Turning the panel lock off
Touch Panel Lock for 4 seconds. The child lock is now
deactivated.
CAUTION
9
The child lock may be accidentally turned on and off
due to:
water spilled during cleaning
▯
food that has overflowed
▯
objects being placed on the Panel Lock key.
▯
Automatic panel lock
With this function, the panel lock is automatically
activated whenever you turn off the cooktop.
Switching on and off: You can find out how to switch the
automatic panel lock on in the section ~ "Basic
settings"
Basic settings
The appliance has various basic settings. You can adjust
these settings to the way you usually cook.
Display
Function
Automatic child lock/panel lock
™‚
‹
Off*
‚
On
Audible signals
™ƒ
‹
Confirmation signal and error signals deactivated
‚
Only error signals activated
ƒ
Only confirmation signals activated
„
All signals activated*
Automatic timer
™†
‹
Off*
‚
ŠŠ
-
™‡
Length of timer end signal
‚
10 seconds*
ƒ
30 seconds
„
1 minute
Ú
indicator over
Automatic shut-off time
Wipe Protection
Cleaning the control panel while the cooktop is on may
change the settings. In order to avoid this the cooktop
has a wipe protection function.
To activate: Touch the Panel Lock key. The
above the key lights up. The control panel is locked for
35 seconds.
You can now clean the surface of the control panel
without risk of changing the settings.
To deactivate: To deactivate the function before the time
has elapsed, touch the Panel Lock key. The
above the key turns off, the function is deactivated.
Notes
An acoustic signal sounds 30 seconds after activation.
▯
This indicates that the function is about to finish.
The wipe protection function does not lock the main
▯
switch. The cooktop can be switched off at any time.
Automatic time limitation
If the element is used for prolonged periods of time
without changes in the settings being made, the
automatic time limitation function is triggered.
The element stops heating.
•
œ
indicator
/
flash alternately in the display.
The indicator goes out when any symbol is pressed. The
element can now be reset.
When the automatic time limitation is activated depends
on the selected heat level (from 1 to 10 hours).
Ú
indicator
Ú
indicator
"‰
and the residual heat
17
Publicité
