Agilent IDP-3 Mode D'emploi page 165

Technical Information
Figure 21 Grounding Plug and Outlet
If the product must be reconnected for use on a different type of electric
WARNING
circuit, the connector should be replaced by qualified service personnel.
Grounding Instructions (DC version)
Ensure the 24 VDC power supply and 0-10 V power supply are grounded according
NOTE
to the correct practice.
Extension Cords
If you must use an extension cord with this product:
Agilent recommends using only extension cords with a minimum of 16-gage

wire and a maximum length of 25 feet (7.6 m).
Use only a 3-wire extension cord that will accept the plug.

Make sure your extension cord is in good condition.

Be sure the extension cord is rated high enough to carry the current your

product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating.
Grounded
Outlet
Box
Ground
Pin
Grounded
Outlet
165