Agilent IDP-3 Mode D'emploi page 149

Instructions for Use
Maintenance
Personnel responsible for pump operation and maintenance must be well-trained
and aware of the accident prevention rules.
• Death or serious injury may result from contact with high voltages. Always
WARNING
take extreme care and observe the accident prevention regulations in force.
• When the pump is powered up, be careful of moving parts and high voltages.
• If you have to perform maintenance on the pump after a considerable time in
operation, allow it to cool as the temperature of the outer surface may be in
excess of 60 °C.
• Always disconnect your power supply to the pump before beginning
maintenance work.
Before returning the pump to the factory for repair, the "Request for Return" sheet
NOTE
attached to this instruction manual must be completed and sent to the local sales
office. A copy of the sheet must be inserted in the pump package before shipping.
If a pump is to be discarded, it must be disposed of in compliance with local laws
and regulations.
Cleaning
During prolonged operation in low flow applications, dust and debris can build up in
the pump. For optimum performance Agilent recommends running the pump
periodically at atmosphere for a minute or two to flush it out. Until experience is
gained on your specific process, flush the pump regularly and adjust this schedule
according to your specific conditions.
Exterior
The exterior surfaces of the IDP-3 may be cleaned with alcohol or mild detergents
only.
149