Fuse Replacement - Sony XAV-AX7000 Mode D'emploi

When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General] to [Preset].
Using the rear view camera
Installation of the rear view camera (not supplied) is
required before use.
The picture from a rear view camera connected to
the CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
Installation
Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.
CAUTION
Do not touch the left side of the unit when
removing from the dashboard. The heatsink on
the left side of the unit remains hot right after
use.

Bracket
Parts supplied with
your car
When mounting this unit to the preinstalled
brackets of your car, use the mounting screws  in
the appropriate screw holes based on your car:
T for TOYOTA and N for NISSAN.
Note
To prevent a malfunction, install only with the mounting
screws .
To the dashboard/center console
Bracket

Fuse replacement

When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse.
If the fuse blows, check the power
connection and replace the fuse.
If the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.

Fuse (15 A)
15
GB