CYBEX gold ATON G SWIVE Mode D'emploi page 58

Installing and Removing the Infant Car Seat ONLY
Installing the Infant Car Seat With Lap/Shoulder Belts (Alternate)
3. LOCK your vehicle lap Shoulder Belt.
Refer to your vehicle owner's manual for
how your vehicle Lap and Shoulder Belt
locks.
In many vehicles, you can switch the
Shoulder Belt Retractor into locking
mode by pulling the Shoulder Belt out
all the way. Check the vehicle owner's
manual to see how your system locks.
To check if the vehicle belt is locked,
after you install the Infant Car Seat, pull
up firmly on the Lap Belt between the
Belt Guides. The belt should remain tight
if the vehicle system is locked.
4. Push Infant Car Seat firmly into vehicle
seat, pressing down near the Buckle
Strap between the child's legs A
removing slack from Lap Belt B
for Shoulder Belt.
58
e e
r r
, while
A
. Repeat
B
B B
A A