CYBEX gold ATON G SWIVE Mode D'emploi page 45

Installing and Removing the Infant Car Seat with the Base
Installing with Base Using Lap/Shoulder Belts
6. Press down on the sides of the
SafeLock Belt Tensioner until an audible
CLICK is heard. If Belt Tensioner does
not lock, try loosening the vehicle belt
slightly, then try to close again.
7. Grab the Base at the Belt Path and pull
from side to side and front to back to
make sure it is installed correctly. The
Base should not move more than 2.5 cm
(1 in) in any direction.
If the Base moves too much, open the
SafeLock Belt Tensioner and remove a
little more slack from the vehicle belt,
then close and recheck. After this, if
the Base still moves too much, you
may need to try a different vehicle seat
location or installation method, or both.
y y
u u
CLICK!
45