CYBEX gold ATON G SWIVE Mode D'emploi page 40

Installing and Removing the Infant Car Seat with the Base
8. Grab the Base at the Belt Path and pull
from side to side and front to back to
make sure it is installed correctly. The
Base should not move more than 2.5 cm
(1 in) in any direction.
If the Base moves too much, open the
SafeLock Belt Tensioner and remove a
little more slack from the LATCH/UAS
Strap, then close and recheck. After this,
if the Base still moves too much, you
may need to try a different vehicle seat
location or installation method, or both.
9. Place the Infant Car Seat into the Base,
and listen for a CLICK. Check that the
Car Seat is installed by lifting up on the
Handle (see pg. 34).
40
Installing with Base Using LATCH/UAS
i i
o o
CLICK!