CYBEX gold ATON G SWIVE Mode D'emploi page 55

Installing and Removing the Infant Car Seat ONLY
Installing the Infant Car Seat With Lap/Shoulder Belts
5. Push Infant Car Seat firmly into vehicle
seat, pressing down near the Buckle
Strap between the child's legs A
removing slack from Lap Belt B. Repeat
for Shoulder Belt.
6. Make sure that vehicle belt buckle and
hardware do not interfere with the Infant
Car Seat.
7. Check the recline angle. Adjust the seat
angle until the WHITE LEVEL LINE
on the Infant Car Seat is level with the
ground. A tightly rolled towel or pool
noodle (pg. 30) may be placed under the
Infant Car Seat, near the vehicle seat
back, to adjust the angle, if necessary.
t t
while
A
A A
u u
y y
B B
FRONT OF VEHICLE
White line MUST be parallel to
ground when seat is installed in
vehicle without base
55