CYBEX gold ATON G SWIVE Mode D'emploi page 57

Installing and Removing the Infant Car Seat ONLY
Installing the Infant Car Seat With Lap/Shoulder Belts (Alternate)
Use this alternate installation method only when the preferred method found on
pages 53-56 does not work with your vehicle Lap and Shoulder belts.
WARNING!
!
• NEVER install this Child Restraint using a non-locking vehicle Lap/Shoulder Belt. A
locking clip must be used with a vehicle belt that DOES NOT LOCK. Call ParentLink
Customer Service at 1-877-242-5676 to obtain a locking clip.
• ALWAYS have the Handle in a LOCKED position while using this Child Restraint in a
vehicle (see pg. 26).
• NEVER INSTALL the Infant Car Seat with both the Lap and Shoulder Belts routed
through the Lap Belt Guides.
1. Position Infant Car Seat firmly against
the back of the rear vehicle seat as
shown.
2. Route only the vehicle Lap Belt through
the blue INFANT CAR SEAT LAP BELT
GUIDES and BUCKLE THE BELT.
Route the SHOULDER PORTION
diagonally across the vehicle seat back
as shown.
DEATH or SERIOUS INJURY can occur.
q q w w
CLICK!
57