WAGNER W 510 Manuel D'utilisation page 36

Les langues disponibles

3) Unscrew the union nut and remove the air cap and nozzle. (Fig. 11)

Clean the air cap, nozzle seal and nozzle with a brush and solvent or water.

4) Clean the outside of the spray gun and container with a cloth soaked in solvent or

water.

5) Assemble the parts again (see "Assembly").

Assembly

Attention! Never operate the device if the nozzle seal is either damaged or

missing. If the nozzle seal is either missing or damaged liquids can enter

the device and increase the risk of an electric shock.

1) Push the nozzle seal (fig. 12, 1) over the needle (3); the groove (slot) should point

towards you.

2) Put the nozzle (fig. 12, 2) onto the gun body and find the correct position by turning it.

3) Put the air cap onto the nozzle and tighten it using the union nut.

4) Place the container seal from below on the suction tube and slide it over the collar,

while turning the container seal slightly.

5) Insert the suction tube with container seal in the gun body.

In order to mount the gun more easily apply lubricating grease (enclosed) liberally

to the O-ring at the gun front part. (Fig. 14, 5 and fig. 15, 5)

17. Maintenance

Air filter

WARNING! Never operate the machine without the air filter;

dirt could be sucked in and interfere with the function of the

machine. Check the air filter after each use for contaminants.

Disconnect plug before changing parts.

1) Open the air filter cover. (Fig. 13)

2) Pull out the air filter and replace it if necessary, depending on how soiled it is.

Ventilating hose / Valve

1) Pull the ventilating hose (Fig. 10, 1) at the top from the gun body. Screw off the valve

cover (2). Remove the diaphragm (3). Carefully clean all parts or replace in the

event of damage.

2) Place the diaphragm (Fig. 10, 3) with the pin facing upwards on the bottom section

of the valve. Also see the marking on the gun body.

3) Place on the valve cover (Fig. 10, 2) and screw it closed.

4) Place the ventilating hose (Fig. 10, 1) on the valve cover and on the nipple at the gun

body.

W 510