Bluetooth Device - Sony MEX-N6002BD Mode D'emploi

Pairing and connecting with a

BLUETOOTH device

When connecting a BLUETOOTH device for the first
time, mutual registration (called "pairing") is
required. Pairing enables this unit and other devices
to recognize each other. This unit can connect two
BLUETOOTH devices (two cellular phones, or a
cellular phone and an audio device).
1
Place the BLUETOOTH device within 1 m
(3 ft) of this unit.
2
Press MENU, rotate the control dial to
select [BLUETOOTH], then press it.
3
Rotate the control dial to select [SET
PAIRING], then press it.
4
Rotate the control dial to select [SET
DEVICE 1]* or [SET DEVICE 2]*, then press
it.
flashes while the unit is in pairing standby
mode.
* [SET DEVICE 1] or [SET DEVICE 2] will be changed
to the paired device name after pairing is
complete.
5
Perform pairing on the BLUETOOTH
device so it detects this unit.
6
Select [MEX-N6002BD] shown in the
display of the BLUETOOTH device.
If your model name does not appear, repeat
from step 2.
7
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "Passcode," "PIN code,"
"PIN number" or "Password," etc., depending on
the device.
Input passkey
[0000]
When pairing is made,
8
GB
stays lit.
8
Select this unit on the BLUETOOTH device
to establish the BLUETOOTH connection.
or lights up when the connection is made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for this
unit from another device.
To start playback
For details, see "Playing a BLUETOOTH Device"
(page 13).
To disconnect the paired device
Perform steps 2 to 4 to disconnect after this unit
and the BLUETOOTH device are paired.
Connecting with a paired BLUETOOTH
device
To use a paired device, connection with this unit is
required. Some paired devices will connect
automatically.
1
Press MENU, rotate the control dial to
select [BLUETOOTH], then press it.
2
Rotate the control dial to select [SET BT
SIGNL], then press it.
Make sure that lights up.
3
Activate the BLUETOOTH function on the
BLUETOOTH device.
4
Operate the BLUETOOTH device to
connect to this unit.
or lights up.
Icons in the display:
Lights up when handsfree calling is
available by enabling the HFP (Handsfree
Profile).
Lights up when the audio device is
playable by enabling the A2DP
(Advanced Audio Distribution Profile).
To connect the last-connected device from
this unit
Activate the BLUETOOTH function on the
BLUETOOTH device.
To connect with the audio device, press SRC to
select [BT AUDIO] and press PAUSE.
To connect with the cellular phone, press CALL.