Publicité
Les langues disponibles
Les langues disponibles
Teflon Retaining Pin
Fig. E
Fig. F
PLATE GAP ADJUSTER
Fig. G
3. Raise the platen to the 53° raised
position. Drape the Teflon sheet
from the right side of the platen by hooking the
front and back of the Teflon bracket to the
Teflon retaining pins. See Fig. E.
4. Pull the Teflon sheet from the right side
around the face of the platen cooking
surface to the left side.
5. Pull the Teflon sheet tight and ensure the
cooking surface of the platen is completely
covered by the Teflon sheet.
Teflon Clip
6. Secure the Teflon sheet to the left side of
the platen with the two Teflon clips.
clips down over the Teflon sheet, clipping onto
the round rods underneath the sheet.
Fig. F.
The plate gap adjuster is used to prevent soft
foods from being crushed by the downward force
of the unit. The "1" setting would be used for the
smallest or no gap with "4" being used to create
the largest gap.
Settings are changed by rotating the gap
adjuster body to the left or right until it locks in
place at the desired setpoint.
7
-
-
Push the
See
Publicité
