Vulcan VMCS Serie Manuel D'utilisation Et D'installation page 14

Fig. 10
Fig. 11
Fig. 12
11. Drill two holes with 5/32" bits through
GRIDDLE TOP INSTALLATION
Mounting Plate
12. Attach masking tape to mounting plate and
Griddle top
mounting point
13. Use tape to align holes in mounting plate
14
- -
It may be necessary to
angle the griddle and hang one of the
four legs off the edge of the table at a
time to complete step 11. Ensure that
the griddle is safely supported and this
step is accomplished with aid of a
second person.
bottom support brackets and into the
bottom of griddle chassis. Insert and
tighten 10-24 x 2" screws as shown in
Fig.10. Repeat as necessary for all bottom
support brackets.
slide into position between the griddle back
panel and the top of the selected griddle
top mounting point as shown in
Fig. 11.
Mounting Plate
with holes in griddle top mounting point as
shown in Fig. 12. Tape to hold in position
until installation of griddle top is complete.
Repeat steps 12 and 13 for the bottom
mounting point.