Publicité
Les langues disponibles
Les langues disponibles
EXTENDED SHUTDOWN
1. Set the power switch to the OFF position. This will shut down the griddle top
completely.
2. Leave unit in the raised, 53° position.
3. Apply a light coating of cooking oil on the grooved (steel) plate to inhibit rust.
4. Shut off the main electrical supply
MAINTENANCE
The griddle and its parts are hot. Use care when operating, cleaning
or servicing the griddle.
Disconnect power supply and follow lockout / tagout procedures
before cleaning and servicing the appliance.
LUBRICATION
There are no parts on this unit that require lubrication.
SERVICE AND PARTS INFORMATION
Contact the Authorized Service Contractor in your area to obtain service and parts
information.
For
a
complete
listing
of
Service
and
Parts
depots
refer
to
www.vulcanequipment.com.
When calling for service the following information should be available from the appliance
serial plate: Model Number, Serial Number and voltage.
FIELD INSTALLATION ASSEMBLY
Contact the authorized service contractor in your area for field installation.
The field installation instructions are prepared for the use of trained service technicians and should only
be used by those who are properly qualified. These instructions are not intended to be all
encompassing. You should read, in its entirety, the installation instructions to determine if you have the
necessary tools, instruments and skills required to perform the procedure. The field installation should
not be attempted if you do not have the necessary tools, instruments and skills.
TOOLS REQUIRED FOR FIELD INSTALLATION
1. #2 Philips head screw driver
2. M10 socket driver
3. 7/16" socket driver
4. Rubber mallet
5. Power drill
6. 7/8" deep well socket wrench
7. (2) large "F" clamps
8. 5/32" drill bits for metal
9. Thread lock compound (Loctite Blue®)
10. ¾" wide masking tape
10
-
-
Publicité
