Publicité
Les langues disponibles
Les langues disponibles
Fig. 7
Fig. 8
Fig. 9
Bottom support
bracket
13
-
-
8. Drill the remaining holes through the
side mounting brackets into the griddle
chassis. Insert and tighten screws as
shown in Fig. 7. Repeat procedure for
the other side of the assembly.
9. Drill holes with 5/32" bits from the rear of
the side mounting bracket into the back
mounting bracket and install wall spacer
with (4) 10-24 x ½" screws as shown in
Fig. 8. Repeat procedure for the other
side of the assembly.
Wall Spacer
10. Install one bottom support bracket every
two feet of griddle width between griddle
top mounting points as needed for
additional
support.
brackets should be flush with bottom of
griddle chassis and back mounting
bracket. Drill two holes with 5/32" bits
and attach with 10-24 x 2" screws as
shown in Fig.9 to the back mounting
bracket.
Repeat
support bracket needed.
Bottom
support
for
each
bottom
Cutaway
side view
Publicité
