Publicité
Les langues disponibles
Les langues disponibles
BRACKET ASSEMBLY AND INSTALLATION
The griddle and its parts are hot. Use care when operating, cleaning
or servicing the griddle.
Disconnect power supply and follow lockout / tagout procedures
before cleaning and servicing the appliance.
Fig. 1
Griddle Top
Assembly Mounting Points
Fig. 2
Fig. 3
Prior
to
mounting bracket is the correct size. The
back bracket should match the width of
the griddle. Make sure the griddle top
electrical
available service.
require its own separate electrical service.
1. Using (2) washers and (2) ¼"-28 bolts,
assemble one of the side mount
brackets to the back bracket as shown
in Fig. 1. The bolts should be hand
tightened only at this point. Repeat
procedure to attach the other side
mount bracket to the other end of the
back bracket.
2. The entire mounting bracket system
should be assembled at this point as
shown in Fig. 2 with bolts hand
tightened only.
3. Slide mounting bracket system onto
back of the griddle as shown in Fig. 3.
The left and right side brackets should
be pushed up until stopped by the
bottom of the griddle and pushed
forward until stopped by the griddle
back panel.
bracket system at this location with a
"F" clamp on each side of the assembly
as shown. Place a wood block or other
type of protection between clamp and
griddle plate.
11
-
-
assembly,
make
sure
specifications
match
Each griddle top will
Secure the mounting
the
the
Publicité
