Publicité
Les langues disponibles
Les langues disponibles
Fig. B
Raised Position
Fig. C
Lowered Position
TEFLON WRAP INSTALLATION
Teflon Bracket
Fig. D
Teflon Sheet Sleeve
To raise the assembly
1. Lift by the handle only
2. Hold handle until assembly holds in
place at the approximate 53° position.
Fig. B
maintain control of the unit until lifting
mechanism holds in the desired raised
position or rests in the lowered position.
Do not allow unit to swing upward or
downward under its own power as this
may result in injury or equipment damage.
To lower the assembly
1. Grasp the handle and pull downward.
Continue to hold handle until the unit
stops in lowered position. Fig. C
Do not force unit if it does not
move up and down in the prescribed manner.
The assembly may be damaged by the
application of excessive upward or downward
force. Contact an authorized service
contractor if assembly becomes difficult to
move.
are hot. Use care when operating,
cleaning or servicing the griddle.
1. Clean off platen using soft cloth, water
and mild soap solution.
2. Slide the Teflon bracket (#944503) into
the sleeve of the Teflon sheet as shown
in Fig. D.
6
-
-
Always hold handle to
The griddle and its parts
Publicité
