Description - Waldmann ABLTL 1 Mode D'emploi

GB Instructions For Use Machine Light ABLTL 1

Description

Fig. 11a
Fig. 11b
22
According to standard DIN EN 1837 , an illuminance of 500 lx is required in the work area of machines. This is
often impossible to achieve using a light that is not in the immediate proximity of the tool. However, only in rare
cases is it possible to attach a light directly to the tool slide, since the restricted room available in the interior of
the machine room does not allow this.
In the ideal case, a well illuminated machining area is can be achieved by combining 2 or more lights:
a) Light for basic illumination of the machining area (using, for example, a Waldmann protective-tube light)
b) additionally mounted light for the immediate machining area (e.g. Waldmann machine light ABLTL 1).
The machine light ABLTL1 meets the requirements of the standard since the flexible light-supporting hose (swan
neck) allows virtually any positioning of the light. Mounting such a light, in addition to the basic illumination already
in place, offers a maximum degree of illumination comfort at the machine.
The use of light emitting diodes (LED) instead of halogen lights allows a significantly higher service life to be
achieved. This results in fewer machine downtimes as a result of maintenance work.
A housing made of anodized aluminum and a protective borosilicate glass pane are resistant to hot and sharp-
edged chips. The housing is waterproof and, like the PUR cable, resistant to coolants and lubricants.
The selection between 3 variants of different radiation characteristics (6°, 15°, 25°) makes for universal use.