Sgcp Model Installation - Hatco SGPT-24 Manuel D'installation Et D'utilisation

English

SGCP Model Installation

NOTE: Remove tape and protective packaging from the
surfaces of the unit.
1. Slide the mounting cover, side glass clamp, then the sneeze
guard mounts onto each post.
2. Slide the angle adjustment pins through the spacer and into
the sneeze guard mount holes. Repeat on opposite post.
3. Slide the glass mounting bracket through the angle
adjustment pins. make sure both sides are inserted into the
pins the same way to ensure both sides are angled properly
for a correct fit. The unit is designed for a 60° angle.
4. Secure the glass mounting bracket into place by tightening
the knob into the post.
5. Secure the top glass sneeze guard.
a. Insert the mounting bolt through the glass sneeze guard.
b. Place a glass bushing between the glass sneeze guard
and the glass mounting bracket.
c. Screw the mounting bolt into the glass mounting bracket.
d. Repeat on the three remaining glass sneeze guard
holes.
6. move the sneeze guard mounts to the desired position and
secure to the post using the knob. The bottom edge of the
top glass must be 52" (1321 mm) or less above floor.
Form No. SGm-0815
Glass
Bushing
Knob
Glass
Mounting
Bracket
Angle
Side
Adjustment
Glass
Spacer
Clamp
Knob
Mounting Cover
Countertop Mounting
Screw
SGCP model Installation
7. Place the posts in the desired location and secure the legs
into the countertop.
• move the mounting covers to access the mounting holes.
• Use the "mounting Template" located in the aDDENDUm
section at the end of this manual.
8. Secure the side glass to the outside of each post.
a. Tighten the short knob into the top hole.
b. Place a glass bushing between the side glass and the
post.
c. Hold the side glass clamp onto the post.
d. Tighten the long knob into the bottom hole through the
glass bushing and into the post.
e. Repeat this step on the opposite end.
Mounting Bolt
Angle Adjustment
Pins
Post
Sneeze Guard
Mount
7
INSTALLATION
Short
Knob
Long
Knob