Mounting Template; Addendum - Hatco SGPT-24 Manuel D'installation Et D'utilisation

English

Mounting Template

Use the following template for accurate mounting screw
locations. make sure the page has not been scaled in size.
measure the box on the bottom right of this page to check
accuracy.
Use the following steps to use the template.
1. Cut out templates.
2. Select position to mount unit.
3. Tape the template on the countertop at the appropriate
position.
4. measure from the center of the template to the center of the
next leg and tape another template to the countertop. Refer
to "Dimensions" in the Specification section.
5. If unit has four legs, repeat step 4. If unit has two legs,
proceed to the next step.
6. mark and drill holes into the three "Drill Here" locations on
each template.
Drill
Here
Drill
Here
Drill
Here
Drill
Here
Form No. SGm-0815
Drill
Here
Drill
Here
Drill
Here
Drill
Here
Drill
Here
Drill
Here
11

ADDENDUM

Drill
Here
Drill
Here
This box is
2" x 2" when
printed
correctly.
Check page scaling if box
is not 2" x 2" when printed.