Publicité
Les langues disponibles
Les langues disponibles
When removing front panel plate
Do not throw away the front panel plate,
since it will be needed when you change
the car you install the unit.
For details, see "Removing the Front
Panel Plate". (page 17).
Note
• Do not press the front panel buttons of
the unit during installation and do not
apply strong force.
• Do not place any objects on top of the
unit.
8
Downloaded from:
https://www.usersmanualguide.com/
Toyota cars (illustration show s an example for a Toyota car)
Align the brackets of the factory-installed car stereo with the
mounting holes marked "T" on the side of the Media Center main
unit, and use the supplied screws to fasten the brackets. For
Toyota cars, the supplied screws 6 should be used.
Front panel
plate 4
Nissan cars
Align the brackets of the factory-installed car stereo with the
mounting holes marked "N" on the side of the Media Center
main unit, and use the supplied pan-head screws 6 to fasten the
brackets.
* Be sure to use only the supplied pan-head screws 6 for
installation. If any other screws are used, make sure they
conform to the requirements shown below.
Using longer screws can cause internal damage to the unit.
Damage can also occur if the screws are used directly on the
unit without the brackets of the factory-installed car stereo.
6
Screw s of factory-
installed car stereo
bracket
6
Screw s of factory-
installed car stereo
bracket
5 mm
6 mm
Bracket of
factory-installed
car stereo
Bracket of
factory-installed
car stereo
Publicité
