Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
before cleaning the appliance, disconnect it
from the gas and electricity supplies.
2) WORKTOP
If you wish to maintain the shine of the glass, is
very important to clean the hob every time you use
it with lukewarm soapy water, rinsed and dried.
The enamelled grids, enamelled covers "C", and
burner heads "M" (see fig. 4) must also be washed
and the ignition elements "AC" and flame sensors
"TC" (see fig. 5) must be cleaned. Do not wash
them in the dishwasher.
Cleaning operations must be carried out when the
hob and components are not hot and the use of
metal scouring pads, powder abrasives and
corrosive sprays must be avoided.
Do not allow vinegar, coffee, milk, salt water,
lemon juice or tomato juice to remain in prolonged
contact with the surfaces.
CERAMIC GLASS
If you wish to maintain the shine of the ceramic
surface, treat the glass with a silicon-based film
product before use to protect the surface against
water and dirt. This protective film is not durable,
so it is advisable to repeat the application of the
product frequently.
It is very important to clean the hob every time you
use it, while the glass is still warm.
Do not clean using abrasive metal scourers,
powder abrasives or corrosive sprays.
Depending on the degree of dirt, we recommend:
- for light stains, a damp sponge is sufficient.
- Tough, encrusted dirt is easily eliminated using a
scraper (fig. 5/A), not supplied with the hob, but
easy to find in local stores. Use the scraper
carefully to avoid damaging the hob.
- Traces of liquid spilled from pans can be
eliminated with vinegar or lemon juice.
- Never allow sugar or sugary foods to fall on
the hob while cooking. Should this occur,
All manuals and user guides at all-guides.com
CLEANING
FIG. 4
switch off the hob and clean it immediately
with hot water, using a scraper on hot spills.
- As time goes by metallic reflections, colouring or
scratches may appear due to poor cleaning and
the incorrect movement of pans. Scratches are
hard to eliminate but do not affect the correct
operation of your hob.
WARNINGS:
when reassembling the components, observe
the following recommendations:
●check that the holes in the burner heads "M"
(fig. 4) are not blocked by foreign bodies.
●Ensure that the enamelled covers "C" (fig. 4)
are correctly positioned on the burner head.
The covers are correctly positioned on the
head when they are perfectly stable.
●Do not use jets of steam to clean the
appliance.
●To prevent difficulties with lighting, regularly
clean the ignition elements (ceramic and
electrode) and flame sensors.
Note:
continuous use could cause the burners to
change colour due to the high temperature.
FIG. 5/A
FIG. 5
9
Publicité
