Teka CGW LUX 60 TC 4G AI AL CI Mode D'emploi page 6

All manuals and user guides at all-guides.com
USE
By pressing the Clock button (11) it is possible to return to the timer programming mode to display the
time left until switch-off or to change the current settings.
The timer can be programmed only when the burner is on, and the count will start immediately after the
burner has been switched on. When the count ends, the timed burner is switched off and a sequence of
beeps lasting 30 seconds will be emitted (the beeping can be stopped by pressing the Clock button (11).
The switching off of the programmed burner by the user will deactivate the relative timer.
Programming the switch-off time of several burners simultaneously
It is possible to programme the switch-off time of several burners that are working simultaneously starting,
as described above for the first burner, when the programming operation has been completed: press the
Clock button (11) and move on to the next burner (this requires no confirmation of the data programmed).
If you wish to programme another burner, before moving on to the next one, confirmation using the clock
button is required.
Regulating the clock
Following a power failure, it will be necessary to set the time displayed on the clock inside the hob.
To regulate the clock it is necessary to switch on hob by pressing the ON/OFF button and simultaneously
pressing buttons 14 and 11 for at least 3 seconds.
The flashing number to the left of the button indicates the hours, while that to the right indicates the
minutes. Pressing buttons 12 and 13 it is possible to increase or decrease the number of hours, and
keeping buttons 12 or 13 pressed varies the number of hours continuously.
To regulate the minutes, press the Clock button (11) again. The numbers to the right of the dot will start
flashing and you can then regulate the minutes in the same way indicated for the hours.
Pressing the Clock button (11) will memorise the time set.
Burner release
Locked burners have the relative display that displays the letter "b". The release is activated by
simultaneously pressing buttons 1 and 14 (for the 90 cm.), the buttons 3 and 14 (for the 60 cm.),
constantly for at least 2 seconds. After release, the burners will be reset at level 0, ready to be switched
on again.
N.B.: if the release procedure is repeated 5 times during a period of 15 minutes, the device will display
FLT06 and will not accept any further request for release for a further 15 minutes.
Child lock function
It is activated only with hob off by pressing the button 14 for at least 3 seconds. The activation of the Child
Lock function is visible through the switching on of the decimal points on the flow rate level displays of
each burner and entails the complete lock of the keyboard.
The function is deactivated by pressing again the button 14 for at least 3 seconds (the unlock of the
keyboard is visible through the switching off of the decimal points on the flow rate level displays).
Keyboard release
The keyboard is released by pressing button 14 for at least 2 seconds. The keyboard release is
manifested with the disappearance of the points on the flame level display.
6