Publicité
Les langues disponibles
Les langues disponibles
REGULATION AND TRANSFORMATION OPERATIONS
Display of the temperature inside the hob
There is a temperature sensor inside the electronic card with which it is possible to show the temperature
inside the hob directly on the timer display. The display is activated by pressing the + and - buttons of burner
1 together with buttons 12 and 13 (for 90 cm), + and - buttons of burner 5 together with buttons 12 and 13
(for 60 cm) continuously for at least 3 seconds. In this condition it is no longer possible to use button 11 for
settings related to the programming of the burner switch-off time.
The same sequence of buttons used to activate the inner display of the temperature must be used to
deactivate it.
Electronic self-diagnosis
The electronic cards constantly control their own status. Should hardware problems or faults inside the card
occur, such as to jeopardise the safety of the end user, the device enters a "safe" status in which the
solenoids are switched off and a code relating to the type of fault appears on the display.
All manuals and user guides at all-guides.com
Type of fault
Single burner locked
Parasite flame/anomaly on
flame sensor circuit on the
single burner
Main valve circuit
anomaly
Reference circuit
voltage anomaly
Watchdog circuit anomaly
Micro-controller doors anomaly
Eprom anomaly
Valve pilot circuit anomaly
Upper limit of 5 releases
in 15 minutes exceeded
Power supply circuit anomaly
Acoustic alarm
anomaly/general anomaly
All burners are locked
Control logic communication errors
Control panel control error
17
Error code
displayed
B
F
Flt00
Flt01
Flt02
Flt03
Flt04
Flt05
Flt06
Flt08
Flt09
Flt0A
Flt0[
Flt0E
Publicité
