Publicité
Les langues disponibles
Les langues disponibles
3) INSERTING THE HOB
After removing the outer and inner packing of the
various mobile parts, ensure that the hob is
undamaged. If you are in any doubt, do not use the
appliance and contact qualified personnel.
The packing elements (cardboard, bags,
polystyrene, nails must not be left within the
reach of children as they are potential sources
of danger.
Make a hole in the worktop to accommodate the
hob, using the measurements indicated in fig. 6,
ensuring that the critical dimensions of the space in
which the appliance must be installed are observed
(see fig. 7).
The appliance must belong to class 3 and is
therefore subject to all the indications of the
standards for such appliances.
The appliance can be installed with just one lateral
wall (to the right or left of the hob), higher than the
hob and positioned at a minimum distance as
described in the table below.
CAUTION:
do not place the glass directly on the unit.
The bottom of the hob must rest on the
unit.
FIG. 8
All manuals and user guides at all-guides.com
INSTALLATION
4) FITTING THE HOB
The hob is equipped with a special seal to avoid
any infiltration of liquid into the unit. To apply this
seal correctly, please follow the instructions given
below carefully:
- remove all the mobile parts of the hob.
- Cut the seal into 4 strips of the lengths suitable to
- Turn the hob upside down and place the adhesive
- Stick the seal to the glass evenly and securely,
- Position the hob in the hole in the unit and fasten it in
- In order to avoid accidental contact with the
- To fasten this product to the supporting structure,
11
fit it along the 4 sides of the glass.
side of the seal "E" (fig. 8) correctly under the
edge of the hob so that the outer edge of the seal
perfectly matches the outer perimeter edge of the
glass. The ends of the strips must match without
overlapping.
using your fingers to press it into place.
place using the appropriate screws "F" of the
fastening hooks "G" (see fig. 9).
surface of the box of the overheated hob during
use, it is necessary to install a wooden divider at a
minimum distance of 70 mm from the top,
fastening it in place with screws (fig. 6).
we advise you not to use mechanical or electrical
screwdrivers and to exercise moderate pressure
by hand on the fastening hooks.
FIG. 9
Publicité
