Sleep Timer Function - Denon AVR-1611 Manuel De L'utilisateur

Sleep timer function

The power automatically goes into standby once the set time has
elapsed.
This is convenient for playing sources while going to sleep.
SLEEP
Press and display the time you
want to set.
The "SLEEP" indicator on the display lights.
• The time switches as shown below each
SLEEP
time is pressed.
OFF 10 min 20 30
120 110 100 90 80
To cancel the sleep timer
SLEEP
Press to set "OFF".
The "SLEEP" indicator on the display turns off.
• The sleep timer setting is canceled if this unit's power is set to
standby or turned off.
• When power to the main zone is
turned off with the sleep timer,
power in ZONE2 is also turned off.
SLEEP
• If on the main unit is pressed,
the same function as with the
remote control unit can be obtained.
Adjusting the volume of the speakers
You can adjust the channel level either according to the playback
sources or to your taste, as described below.
n Adjusting the volume of the different speakers
1
ZONE SELECT
Press
zone mode to "MAIN".
The "MAIN" indicator lights.
2
Press AMP to set the remote
control unit to amplifier
operation mode.
40 50
3
Press CH LEVEL
70 60
Channel Level
FL 0.0dB
C 0.0dB SBR
FR 0.0dB SBL
SW 0.0dB SL
[ ]:CH Sel.
4
Use ui to select the speaker.
The speaker that can be set switches
each time one of the buttons is pressed.
5
Use o p to adjust the volume.
• In the case of a subwoofer, pressing o when it is at "–12 dB" will
change the setting to "OFF".
When a headphone jack is inserted, the headphone channel level can
be adjusted.
to switch the
.
SR 0.0dB
0.0dB
0.0dB
0.0dB
Fader
FRONT : REAR
n Adjusting the volume of groups of speakers
(Fader function)
This function lets you adjust (fade) the sound all at once from the
front (front speaker / front height speaker / center speaker) or rear
(surround speaker / surround back speaker).
1
ZONE SELECT
Press to switch the
zone mode to "MAIN".
The "MAIN" indicator lights.
2
AMP
Press to set the remote
control unit to amplifier
operation mode.
3
Press CH LEVEL .
Channel Level
FL 0.0dB SR 0.0dB
C 0.0dB SBR 0.0dB
FR 0.0dB SBL 0.0dB
SW 0.0dB SL 0.0dB
Fader
FRONT : REAR
[ ]:CH Sel.
4
Use i to select "Fader", then
select the item to be adjusting
using o p.
5
Use o p to adjust the volume of the speakers.
(o : front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker is adjusted
to the lowest value of -12 dB.
ENGLISH
Convenient functions
33