Connecting A Control Dock For Ipod; Connecting An Antenna; Am Loop Antenna - Denon AVR-1611 Manuel De L'utilisateur

ENGLISH

Connecting a control dock for iPod

• Connect a control dock for iPod to the unit to enjoy video and music
stored on an iPod.
• For a control dock for iPod, use ASD-1R, ASD-11R, ASD-3N, ASD-
3W, ASD-51N and ASD-51W made by DENON (sold separately).
• For instructions on the control dock for iPod settings, refer to the
control dock for iPod's operating instructions.
Control dock for iPod
ASD-51N
R L
z
R L
zUse the AV/Control Cable supplied with the DENON
control dock for iPod.
in Set as Necessary
Set this to change the digital input connector to which the input
source is assigned.
"Input Assign" (vpage 41)
18

Connecting an antenna

• Connect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
(vpage 23 "Listening to FM/AM broadcasts"), fix the antenna with
tape in a position where the noise level becomes minimal.
Direction of broadcasting station
FM outdoor
antenna
75 Ω coaxial
cable
q
FM indoor
antenna
(supplied)
Black
White
AM outdoor
Ground antenna
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the

AM loop antenna

rear and bend it forward.
(supplied)
2
Insert the projecting part
into the square hole in
the stand.
w e
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Standing alone
Use the procedure shown left to assemble.
Stand
Square
hole
Loop
Projecting
antenna
part
Nail, tack, etc.