Publicité
Les langues disponibles
Les langues disponibles
GB
6.3
Fitting and removing the rechargeable
battery (03)
IMPORTANT! Danger of damage to the re-
chargeable battery. If the rechargeable battery
is left in the appliance after use, it may damage
the rechargeable battery.
■
Immediately after use, pull the rechargeable
battery out of the appliance and store in a
frost-protected area.
■
Only insert the rechargeable battery in the
appliance immediately before starting work.
Installing the battery
1. Push rechargeable battery (03/1) into the bat-
tery slot until it engages (03/a).
Removing the battery
1. Press and hold the unlocking button (03/2) on
the rechargeable battery.
2. Pulling out the rechargeable battery (03/b).
7 OPERATION
WARNING! Risk of injury due to detach-
ing appliance parts. Appliance parts detaching
during operation can lead to serious injury.
■
Before turning the appliance on, check that
all the parts of the appliance are firmly tight-
ened.
■
Attach cutting tools so that they cannot de-
tach during operation.
7.1
Switching the appliance on and off (04)
1. Stand securely.
2. Hold the appliance with both hands. Do not
rest the cutter head on the ground when do-
ing this.
3. Hold auxiliary handle (01/5) in one hand and
upper grip (01/1) in the other hand.
4. Press unlocking button (04/1).
5. Press ON/OFF switch (04/2) and hold. The
appliance starts. The unlocking button can be
released.
6. Allow the lawn trimmer to run at idling speed
for a few moments. This causes the cutting
line to be cut off to the correct length.
7. The appliance switches off if the ON/OFF
switch is released.
26
WARNING! Danger of cutting injuries. Af-
ter the appliance has been switched off, the spool
head continues to rotate for a few seconds.
Reaching into the spool head during this time can
result in cutting injuries.
■
Wait until the spool head has come to a com-
plete standstill.
7.2
Adjusting auxiliary handle (05)
The angle of the handle can be individually adjust-
ed using the unlocking lever in the auxiliary handle.
1. Pull unlocking lever (05/1) outwards (05/a).
2. Tilt (05/b) auxiliary handle (05/2).
3. Release unlocking lever.
7.3
Prolonging the cutting line during
operation
The cutting line shortens during operation and
frays out.
1. When the ON/OFF switch is pressed and the
spool is rotating: Tap spool head on the lawn
from time to time. This unwinds a piece of
new cutting line from the spool and the line
cutter cuts off the used line end.
7.4
Adjusting telescopic pole (06)
The telescopic pole is infinitely adjustable. The
length can thus be adapted individually to your
height. The telescopic pole can be lengthened or
shortened by 10 cm.
1. Turn locking sleeve (06/1) in the direction of
the open padlock (06/a) until the clamp is re-
leased.
2. Lengthen or shorten (06/b) telescopic pole
(06/2) individually according to your height.
3. Tighten the locking sleeve (06/a).
7.5
Swivelling cutter head (07, 08)
For trimming lawn edges, for example, it is possi-
ble to swivel the cutter head through 180° (07, 08).
1. Pull telescopic handle (07/1) slightly upwards
(07/a).
2. At the same time, turn cutter head (07/2)
through 180° (07/b) until it engages.
3. Allow the telescopic handle to slide down and
engage (07/a).
7.6
Tilting cutter head (09)
By changing the pivot angle, it is also possible to
trim areas that are difficult to access, e.g. under
benches, overhangs, etc.
1. Press the locking button (09/1) and hold (09/a).
Operation
GT 1825
Publicité
