Publicité
Les langues disponibles
Les langues disponibles
Safety
Setting the
Spray Gun
Controls
neveR trigger the gun while adjusting the
adjustment ring. neveR point the spray gun
at any part of the body.
To set the Spray Pattern:
The alignment of the spray pattern can be determined
by turning the adjustment ring (a).
ImpoRTanT: always make sure the connecting nut
(b) is fully tightened before spraying.
It is also possible to switch between a wide ( ) and a
narrow (
) spray fan pattern with the adjustment lever (c).
To set the Material Flow:
The material flow can be adjusted incrementally from 1
(minimum) to 12 (maximum) by turning the adjustable
material flow control (d). Consult Quick Start Guide
below for a starting point.
To set the Air Flow:
Turn the variable speed air control (e) clockwise to
increase the air flow or counter-clockwise to reduce
the air flow (note arrow (f) on body of gun for setting).
Consult Quick Start Guide below for a starting point.
note: Observe the manufacturer's instructions for the
use of the coating material on the material container or
on the technical data sheet.
FLEXSPRAY Quick Start Guide
Fan pattern
Coating
width
1-5 inches
Stain
5+ inches
1-5 inches
Lacquers
5+ inches
1-5 inches
Urethanes
5+ inches
1-5 inches
enamels
5+ inches
1-5 inches
acrylic alkyds
5+ inches
1-5 inches
acrylic Latex
5+ inches
1-5 inches
multi-Color
5+ inches
English
All manuals and user guides at all-guides.com
Notice:
Start
Start
Spray performance will depend upon a number of factors: material thickness, spray
pattern selected, material volume, and air volume. With any type of spray system,
desired spray results will be achieved through some trial and error while adjusting
some or all of these variables.
Review these pages to learn about the spray controls and how they can be used to
acheive the desired spray results.
(width/direction)
FlexFinish front end
FineFinish front end
material
air
material
3
5-8
(Medium)
6
3
5-8
(Medium)
7
2
5-8
(Medium)
5
4
9-12
(high)
8
5
9-12
(High)
9
4
9-12
(High)
9
7
5-8
(Medium)
10
a
b
2
1
12
d
1) Start with a fan pattern for painting
air
7
9-12
(High)
2) Adjust Material & Air Flow settings as
10
7
5-8
(Medium)
10
3) Fine tune the Material and Air Flow
6
5-8
(Medium)
9
4) Use narrow pattern for detailed work,
9
9-12
(High)
11
5) Recommended settings for Material
9
9-12
(High)
11
8
9-12
(High)
11
NA
NA
8
c
f
1
e
trim work (1-5" width) and larger
surfaces like doors and walls (>5"
width).
shown in chart based on coating, fan
pattern width, and Front End.
settings to achieve the best results for
your application.
touch up.
and Air Flow may change if the
coating is thinned.
Publicité
