Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
any attempt to open the motor housing or repair any electrical
parts within the unit by anyone other than an authorized repair
technician could cause serious injury and will void the warranty.
Problem
The unit will not run
Little or no material flow
Material leaking
Spray pattern too thick, runs, spits
and sags
Spray jet pulsates
Too much overspray
Paint in the air tube
This unit contains no servicable electrical parts. Do
not attempt to service yourself. Store indoors with
the power cord wrapped and secured with the velcro
strap.
English
All manuals and user guides at all-guides.com
Cause
1. The power cord is unplugged, or no power
in outlet
2. Device overheated
1. Nozzle clogged
2. Suction tube clogged
3. Material flow setting too low
4. Suction tube loose
5. No pressure build-up in container
6. Container empty
7. Suction tube filter clogged (if applicable)
8. Air tube loose/damaged
9. Paint container seal damaged
10. Air vent on suction tube blocked
11. Air tube valve seal stuck
12. Air filter clogged
1. Air cap, nozzle or needle dirty
2. Front end assembly attachment incorrectly
assembled
3. Nozzle loose
4. Nozzle seal worn
5. Nozzle worn
6. Needle worn
7. Material build-up on air cap and nozzle
1. Material flow setting too high
2. Air flow setting too low
3. Nozzle clogged
4. Air filter clogged
5. Too little pressure build-up in container
6. Viscosity of material too high
7. Air tube loose/damaged
8. Activating the trigger too quickly
9. Applying too much material
10. Distance from the spray object too small
11. Front end assembly not suitable for spray
material
1. Material in container running out
2. Air filter clogged
3. Nozzle seal worn
4. Suction tube loose
5. Suction tube / suction tube filter clogged
1. Gun too far from spray object
2. Too much material applied
3. Air flow setting too high
4. Material has been over-thinned
5. Front end assembly not suitable for spray
material
1. Valve seal dirty
2. Valve seal defective
Solution
1. Plug the power cord into 120V outlet
2. Unplug the power plug, let the device cool down
approx. 30 minutes, check the air filter, do not cover the
intake slots
1. Clean
2. Clean
3. Increase flow
4. Insert
5. Tighten container
6. Refill
7. Clean or use another filter
8. Re-install or replace (see page 13)
9. Replace
10. Clean (see page 10)
11. Clean (see page 13)
12. Clean or replace
1. Clean
2. Assemble correctly (see page 12)
3. Tighten
4. Replace
5. Replace
6. Use new spray attachment
7. Clean
1. Decrease flow setting
2. Increase air flow setting
3. Clean
4. Clean or replace (see page 13)
5. Tighten container
6. Thin
7. Re-install or replace
8. Pull trigger partially until turbine reaches full power
9. Decrease volume setting or increase movement of spray
gun
10. Increase distance to spray object
11. Use a different front end assembly
1. Refill
2. Clean or replace (see page 13)
3. Replace
4. Insert
5. Clean or use another filter
1. Reduce distance
2. Decrease material flow setting
3. Decrease air flow setting
4. Thicken the material by adding more material
5. Use a different front end assembly
1. Clean the valve seal (see page 13)
2. Replace the valve seal (see page 13)
14
Publicité
