Publicité
Les langues disponibles
Les langues disponibles
Introduction
to Paint
Spraying
Introduction
Function description
The paint spraying system consists of a hand-held, motor-operated
turbine, which provides the spray gun with atomization air
In the spray gun, part of the air from the turbine is used to pressurize
the container. This pressure causes the coating material to be fed
through the suction tube to the fluid nozzle where it is then atomized
as it exits the fluid nozzle.
All settings necessary for operation (e.g. material volume, air volume)
can be conveniently adjusted directly on the gun, including start/stop
of the turbine by activating the trigger.
Coating material
Coating Materials Suitable for Use
Water-based and solvent based coatings.
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, caustic solutions
and acidic coating substances. Use extreme caution when using
materials with a flashpoint below 100° F (38°C).
Preparing the coating material
note: Observe the manufacturer's instructions for the use of the
coating material on the material container or on the technical data
sheet.
Coating material purity
An absolute pre-condition for the trouble-free operation of the
FLEXSPRAY system is that the coating material is uncontaminated.
If you have doubts as to the purity of the coating material, we
recommend that you first filter your coating material with a paint
strainer.
All manuals and user guides at all-guides.com
Notice:
Start
Review this page to familiarize yourself with
some general information regarding FLEXSPRAY
paint spraying, including which spray materials
are suitable for use, and how to prepare the
spray material.
3
English
Publicité
