Emergency Calls; Signaling; Quiet Talk (Qt)/ Digital Quiet Talk (Dqt) - Kenwood TK-5720 Mode D'emploi

EMERGENCY CALLS

If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
1 Press and hold the key programmed as Emergency.
• Ask your dealer for the length of time necessary to hold this key before the
transceiver enters Emergency mode.
• When the transceiver enters Emergency mode, it will change to the Emergency
channel and begin transmitting based on how it is set up by your dealer.
2 To exit Emergency mode, press the Emergency key again.
• If the Emergency mode completes a preset number of cycles, Emergency mode will
automatically end and the transceiver will return to the zone and channel that was in
use before Emergency mode was entered.
Note:
◆ Your dealer can set the transceiver to emit a tone when transmitting in Emergency mode.
◆ Your dealer can set the transceiver to emit tones and received signals as normal, or mute the
speaker during Emergency operation.

SIGNALING

■ Quiet Talk (QT)/ Digital Quiet Talk (DQT)

Your dealer may have programmed QT or DQT signaling on your transceiver
channels. A QT tone/ DQT code is a sub-audible tone/code which allows you
to ignore (not hear) calls from other parties who are using the same channel.
Operator Selectable Tone (OST)
If a key has been programmed with OST, you can reprogram the QT/DQT
settings on each of your channels.
1 Select your desired channel.
2 Press and hold the key programmed as OST for 1 second.
3 Press /
• Your dealer can set up to 40 tones/codes.
4 Press to save your new setting.
5 When you have fi nished operating using OST, press the OST key again to
turn the OST function OFF.
■ Network Access Code (NAC)
Your dealer may have programmed a Network Access Code on your
transceiver channels. NAC is a feature of P25 transceivers that functions
similar to QT/DQT; squelch will open when the correct NAC is received.
to select your desired tone or code.
17