Basic Operations; Switching Power On/Off; Adjusting The Volume; Selecting A Zone And Channel - Kenwood TK-5720 Mode D'emploi

SWITCHING POWER ON/OFF

Press and hold
Press and hold
■ Transceiver Password
If the transceiver is password protected, "PASSWORD" will appear on the
display when the power is turned ON. To unlock the transceiver, enter the
password:
1 Select a character using
• If you are using a microphone keypad, you can enter the password by direclty.
2 Press to enter the selected character.
• This step is unnecessary when using the keypad.
3 Repeat steps 1 and 2 to enter the entire password.
• Press
characters.
4 Press or
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
• The password can contain a maximum of 6 digits.

ADJUSTING THE VOLUME

Press the keys programmed as Volume Up/ Volume Down to adjust the volume
level.

SELECTING A ZONE AND CHANNEL

Select the desired zone using the keys programmed as Zone Up/ Zone Down.
Each zone contains a group of channels.
Select the desired channel using the keys programmed as Channel Up/
Channel Down. Each channel is programmed with settings for transmitting and

receiving.

• You can toggle the display between the zone and channel names and numbers by
pressing the key programmed as Display Format, or by accessing the Menu {page 9}.

TRANSMITTING

1 Select the desired zone and channel.
2 Press the key programmed as Monitor or Squelch Off to check whether or
not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the microphone PTT switch and speak into the microphone. Release
the PTT switch to receive.

BASIC OPERATIONS

for approximately 1 second to turn the transceiver power ON.
again to turn the transceiver OFF.
/ .
or # to delete a character. Press and hold
to confi rm the entry.
or # to delete all
7