Emergency Calls - Kenwood NX-5700 Mode D'emploi

If your transceiver has been programmed with the Emergency function, you can make

emergency calls.

Note:
Only the Auxiliary (orange) key can be programmed with the Emergency function.
●
1
Press and hold the key programmed as [Emergency].
Depending on the delay time programmed into your transceiver, the length of time you
●
must hold the Emergency key will vary.
When the transceiver enters Emergency mode, the transceiver will change to the
●
Emergency channel and begin transmitting based on how the transceiver is set up by
your dealer. Transmit periods are also set by your dealer.
2
To exit Emergency mode, press and hold the [Emergency] key again.
If the Emergency mode completes a preset number of cycles, Emergency mode will
●
automatically end and the transceiver will return to the zone and channel that was in
use before Emergency mode was entered.
Note:
Your dealer can set the transceiver to emit a tone when Emergency mode starts and stops.
●
Your dealer can set the transceiver to emit tones and received signals as normal or mute
●
the speaker during Emergency operation.
34
EMERGENCY CALLS