Receiving - Kenwood NX-5700 Mode D'emploi

2
Press and hold the PTT switch to make the call.
Speak into the transceiver as you would during a normal call.
●
The display will alternate between the called Group ID/ name and "Calling".
●
The LCD display will return to the zone and channel screen after call ends.
●
Making Individual Calls (NXDN Trunking)
o
You can make calls to specific persons.
Operate in the same way as you would for Conventional channel. Refer to "Making
Individual Calls (NXDN Conventional)" {p. 9} .

RECEIVING

1
Select the desired zone and channel using the keys programmed as [Zone Up]/
[Zone Down] or [Channel Up]/ [Channel Down] keys. (If the Scan function has
been programmed, you can switch it on or off as desired.)
2
When you hear the caller's voice, readjust the volume as necessary.
If signaling has been programmed on the selected channel, you will hear a call only if
●
the signal tone matches the tone set up on your transceiver.
Note:
Signaling allows your transceiver to code your calls. This will prevent you from listening
●
to unwanted calls. It does not make calls private, it only prevents them from being heard
by transceivers set with a different signaling code. Refer to "SIGNALING" {p. 37} for
details.
A ringing tone will sound when receiving a call if the alert tone has been enabled in the
●
Alert Tone setting. For details, consult your dealer.
Receiving Group Calls (P25)
o
When you receive a group call on a Conventional channel and the received group ID
matches the ID set up on your transceiver, you can hear the caller's voice.
When you receive a group call on a Trunking channel, the transceiver automatically
switches to the traffic channel to receive the call.
11