Kenwood NX-5700 Mode D'emploi page 12

Receiving Individual Calls (P25)
o
When you receive an individual call on a Conventional channel, a ringing tone will
sound and the display will show the caller's ID. To respond to the call, press and hold
the PTT switch and speak into the transceiver as you would during a normal call.
When you receive an individual call on a Trunking channel, a ringing tone will sound
and the caller's ID and "Incoming" appear on the display. To receive the call, press
the PTT switch. To deny the call, press the key programmed as [Clear]. After
receiving the call, you can respond to the call by pressing and holding the PTT switch
and speaking into the transceiver as you would during a normal call. After the call is
finished, press the key programmed as [Clear] to end the call.
Receiving Group Calls (NXDN)
o
When you receive a group call on a Conventional channel and the received group ID
matches the ID set up on your transceiver, you can hear the caller's voice.
When on a Trunking channel, if the Group ID of a received call matches your Group
ID, you will hear the call.
Receiving Individual Calls (NXDN)
o
When you receive an individual call on a Conventional channel, a ringing tone will
sound and the display will show the caller's ID. To respond to the call, press and hold
the PTT switch and speak into the transceiver as you would during a normal call.
When you receive an individual call on a Trunking channel, a ringing tone will sound
and the caller's ID and "Individual" appear on the display. To receive the call, press
the PTT switch. To deny the call, press the key programmed as [Clear]. After
receiving the call, you can respond to the call by pressing and holding the PTT switch
and speaking into the transceiver as you would during a normal call. After the call is
finished, press the key programmed as [Clear] to end the call.
12